Degrees of freedom, law of equipartition of energy and applications to specific heat capacities - Question Bank

1. According to the Law of Equipartition of Energy, how much energy does each translational degree of freedom contribute to the average energy of a molecule?
A) kT
B) kT/2
C) 3kT/2
D) RT
2. The specific heat capacity of a polyatomic gas is generally higher than that of a diatomic gas because:
A) Polyatomic gases have more translational degrees of freedom.
B) Polyatomic gases have more rotational degrees of freedom.
C) Polyatomic gases have more vibrational degrees of freedom.
D) Polyatomic gases have a higher molecular weight.
3. Which of the following molecules has the highest number of degrees of freedom at room temperature, assuming vibrational modes are not active?
A) Helium (He)
B) Nitrogen (N2)
C) Methane (CH4)
D) Carbon Dioxide (CO2)
4. For a monatomic gas, Cv = 3R/2. This implies that its internal energy per mole is directly proportional to:
A) Volume
B) Pressure
C) Temperature
D) Entropy
5. The concept of degrees of freedom is crucial for understanding the microscopic behavior of gases and their macroscopic properties like specific heat. Which law forms the basis for relating degrees of freedom to energy?
A) Avogadro's Law
B) Boyle's Law
C) Law of Equipartition of Energy
D) Charles's Law
6. What is the average energy per molecule for a rigid diatomic gas at temperature T?
A) 3kT/2
B) 5kT/2
C) 7kT/2
D) kT
7. The internal energy of an ideal gas depends only on:
A) Pressure and volume
B) Temperature and degrees of freedom
C) Volume and number of moles
D) Pressure and temperature
8. If the vibrational modes of a diatomic molecule are excited, how does it affect its specific heat capacity?
A) It increases.
B) It decreases.
C) It remains unchanged.
D) It becomes zero.
9. Why is Cv for diatomic gases higher than for monatomic gases?
A) Diatomic molecules have rotational degrees of freedom.
B) Diatomic molecules have vibrational degrees of freedom.
C) Diatomic molecules have more translational degrees of freedom.
D) Diatomic molecules have a higher mass.
10. The specific heat capacity of a gas is a measure of:
A) The kinetic energy of the molecules.
B) The potential energy of the molecules.
C) The heat required to raise the temperature of a unit mass by one degree.
D) The total energy of the molecules.
11. What is the value of 'f' (degrees of freedom) for a rigid triatomic molecule like CO2 at room temperature?
A) 5
B) 6
C) 7
D) 8
12. For a system in thermal equilibrium, the average energy per molecule is distributed equally among all its active degrees of freedom. This is the essence of:
A) First law of thermodynamics
B) Second law of thermodynamics
C) Law of Equipartition of Energy
D) Zeroth law of thermodynamics
13. Consider a system of N molecules, each with f degrees of freedom. The total internal energy U is given by:
A) U = N * f * kT
B) U = N * f * kT/2
C) U = N * kT
D) U = f * kT/2
14. The Law of Equipartition of Energy is a classical result. What is a major limitation of this law?
A) It does not account for translational motion.
B) It fails at very high temperatures.
C) It does not account for quantum mechanical effects at low temperatures.
D) It is only applicable to monatomic gases.
15. If a gas has 6 degrees of freedom, its molar specific heat at constant volume (Cv) would be:
A) 3R
B) 5R/2
C) 7R/2
D) 9R/2
16. The molar specific heat of an ideal gas is defined as the heat required to raise the temperature of one mole of the gas by one Kelvin at constant volume. This relates to:
A) Cp
B) Cv
C) gamma
D) R
17. Why does a triatomic molecule like ozone (O3) have more degrees of freedom than a diatomic molecule like oxygen (O2)?
A) Ozone has more atoms, leading to more possible vibrational modes.
B) Ozone is linear, while oxygen is not.
C) Ozone has a higher molecular weight.
D) Ozone molecules are more energetic.
18. For a non-rigid diatomic molecule, which degrees of freedom are active at moderate temperatures?
A) Translational and rotational only
B) Translational, rotational, and vibrational
C) Translational and vibrational only
D) Rotational and vibrational only
19. Which statement best describes the contribution of rotational motion to the internal energy of a gas molecule?
A) Each rotational degree of freedom contributes kT.
B) Each rotational degree of freedom contributes kT/2.
C) Rotational motion does not contribute to internal energy.
D) Rotational motion contributes 3kT/2 per molecule.
20. The Dulong-Petit law, which approximates the molar specific heat of solids, is a consequence of:
A) Wien's displacement law
B) The Law of Equipartition of Energy
C) Stefan-Boltzmann law
D) Kirchhoff's law of thermal radiation
21. According to the equipartition theorem, the internal energy of one mole of a monoatomic gas is:
A) 3RT/2
B) 5RT/2
C) RT
D) 3RT
22. The specific heat capacity of a solid is often explained using the equipartition theorem. How many degrees of freedom are typically associated with each atom in a solid?
A) 2 (1D vibration)
B) 3 (translational)
C) 6 (3 vibrational + 3 vibrational)
D) 3 (vibrational in x, y, z directions)
23. At very low temperatures, quantum mechanical effects become significant. How does this affect the degrees of freedom considered?
A) All degrees of freedom become active
B) Only translational degrees of freedom are active
C) Rotational and vibrational degrees of freedom freeze out
D) The number of degrees of freedom doubles
24. The Law of Equipartition of Energy is valid under which condition?
A) Quantum effects are dominant
B) The system is in thermal equilibrium
C) The system is at absolute zero temperature
D) The molecules are interacting strongly
25. For a triatomic linear molecule (like CO2) at moderate temperatures, how many degrees of freedom are typically considered?
A) 3 (translational) + 2 (rotational) = 5
B) 3 (translational) + 3 (rotational) = 6
C) 3 (translational) + 2 (rotational) + 2 (vibrational) = 7
D) 3 (translational) + 3 (rotational) + 4 (vibrational) = 10
26. Which of the following is NOT a direct application of the Law of Equipartition of Energy?
A) Calculating specific heat capacities of gases
B) Explaining the photoelectric effect
C) Deriving the internal energy of ideal gases
D) Understanding thermal conductivity of gases
27. The ratio of specific heats (gamma = Cp/Cv) for a triatomic gas (like water vapor) at high temperatures, assuming all modes are active, tends towards:
A) 1.4
B) 1.33
C) 1.67
D) 1.2
28. The ratio of specific heats (gamma = Cp/Cv) for a diatomic gas at moderate temperatures is approximately:
A) 1.4
B) 1.67
C) 1.33
D) 1.2
29. The ratio of specific heats (gamma = Cp/Cv) for a monoatomic gas is approximately:
A) 1.4
B) 1.67
C) 1.33
D) 1.2
30. What is the molar specific heat at constant pressure (Cp) for a diatomic gas when vibrational modes are active?
A) 5R/2
B) 7R/2
C) 9R/2
D) 11R/2
31. What is the molar specific heat at constant pressure (Cp) for a rigid diatomic gas at moderate temperatures?
A) 3R/2
B) 5R/2
C) 7R/2
D) 9R/2
32. What is the molar specific heat at constant pressure (Cp) for a monoatomic gas?
A) 3R/2
B) 5R/2
C) 7R/2
D) 9R/2
33. The molar specific heat at constant pressure (Cp) is related to Cv by:
A) Cp = Cv - R
B) Cp = R - Cv
C) Cp = Cv + R
D) Cp = Cv * R
34. What is the molar specific heat at constant volume (Cv) for a diatomic gas when vibrational modes are active?
A) 5R/2
B) 7R/2
C) 3R/2
D) 9R/2
35. What is the molar specific heat at constant volume (Cv) for a rigid diatomic gas at moderate temperatures?
A) 3R/2
B) 5R/2
C) 7R/2
D) R
36. What is the molar specific heat at constant volume (Cv) for a monoatomic gas?
A) 3R/2
B) 5R/2
C) 7R/2
D) R
37. The molar specific heat at constant volume (Cv) for a gas is related to the internal energy U by:
A) Cv = (dU/dT)
B) Cv = U/T
C) Cv = dU/dT * 1/N_A
D) Cv = U * N_A / T
38. If vibrational degrees of freedom are also active for a diatomic molecule, its internal energy per molecule becomes:
A) 5kT/2
B) 7kT/2
C) 9kT/2
D) 11kT/2
39. For a rigid diatomic gas at moderate temperatures, the internal energy per molecule is:
A) 3kT/2
B) 5kT/2
C) 7kT/2
D) 9kT/2
40. For a monoatomic gas, the internal energy per molecule is equal to the average energy associated with its degrees of freedom. What is this value?
A) kT
B) 3kT/2
C) 5kT/2
D) 7kT/2
41. According to the Law of Equipartition of Energy, the average translational kinetic energy per molecule in any gas is:
A) kT
B) 3kT/2
C) kT/2
D) RT
42. What does 'T' represent in the context of the Law of Equipartition of Energy?
A) Temperature in Celsius
B) Absolute temperature
C) Time
D) Torque
43. What does 'k' represent in the context of the Law of Equipartition of Energy?
A) The number of molecules
B) Planck's constant
C) Boltzmann constant
D) Radius of gyration
44. The Law of Equipartition of Energy states that for a system in thermal equilibrium, the average energy associated with each degree of freedom is:
A) kT
B) kT/2
C) 3kT/2
D) RT
45. At very high temperatures, diatomic molecules can exhibit vibrational motion. How many additional degrees of freedom does this add?
A) 1
B) 2
C) 3
D) 4
46. For a rigid diatomic molecule at moderate temperatures, what is the total number of degrees of freedom?
A) 2
B) 3
C) 5
D) 7
47. What are the types of motion contributing to the degrees of freedom of a molecule?
A) Translational and rotational
B) Translational, rotational, and vibrational
C) Rotational and vibrational
D) Only translational
48. A monoatomic gas molecule possesses how many degrees of freedom at any temperature?
A) 2
B) 3
C) 5
D) 6
49. Which type of molecule has the fewest degrees of freedom?
A) Diatomic molecule
B) Triatomic linear molecule
C) Monoatomic molecule
D) Polyatomic molecule
50. What is the definition of degrees of freedom for a molecule?
A) The number of ways a molecule can move in space.
B) The number of independent ways in which a molecule can store energy.
C) The total number of atoms in a molecule.
D) The number of collisions a molecule undergoes per second.